Getting The Best Swim Spa Cover

Swim Spas represent special obstacles when it pertains to covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same factors a hot tub requires a cover. The challenge is that because of the length of the swim spa and the height of the sides, eliminating and changing the cover can be a lot more difficult.
Getting a brand-new swim spa is an exciting event in life. You’re anticipating the exercise you’ll receive from using it. Possibly you’re a little relieved to have finally made a selection from the different designs you looked at. At any rate, you probably weren’t believing much about the cover you would use.
Typically, the cover that gets back with your new purchase will be a 4 area rigid foam filled cover that will split in the center and go off both ends.
No big deal.
Until it begins to get heavy.
Which it always does.
Every stiff foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design defect. Integrated in obsolescence due to the fact that as quickly as it is positioned in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper won’t make any difference. In fact you might have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The molecules of steam are really small as they rise from the water surface. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being caught in the cover.
It occurs slowly and on a Swim Spa Cover which is made from specific areas, at varying speeds. So eventually you’ll observe one or two of the sections are actually getting heavy. The bar lifters on completions of the swim spa aren’t much assistance since you still need to lift that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com came up with a different style for their Swim Spa Covers
Instead of using numerous foam panels to develop Swim Spa Covers that will ultimately wind up in some landfill, they designed one that uses air chambers that don’t suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate better, won’t blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or fall apart at the joints either. So if you own a swim spa, and you intend to keep using it everyday, SpaCap.com has the cover for it.
If you’re not all set to order today, bookmark this site so you can find it once again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *