The Challenges to Swim Spa Covers

Swim Spas represent distinct obstacles when it pertains to covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same reasons a hot tub requires a cover. The challenge is that because of the length of the swim spa and the height of the sides, getting rid of and changing the cover can be a lot harder.
Getting a new swim spa is an interesting event in life. You’re eagerly anticipating the exercise you’ll get from using it. Possibly you’re a little relieved to have actually lastly selected from the various designs you looked at. At any rate, you most likely weren’t thinking much about the cover you would use.
Normally, the cover that gets back with your new purchase will be a four area rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Up until it starts to get heavy.
Which it constantly does.
Every stiff foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design flaw. Integrated in obsolescence because as quickly as it is put in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper will not make any distinction. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The particles of steam are very small as they increase from the water surface. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being caught in the cover.

It takes place gradually and on a Swim Spa Cover which is made from specific sections, at differing speeds. So eventually you’ll notice one or two of the sections are really getting heavy. The bar lifters on completions of the swim spa aren’t much help because you still have to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com developed a various design for their Swim Spa Covers
Instead of using a number of foam panels to develop Swim Spa Covers that will eventually wind up in some land fill, they designed one that utilizes air chambers that don’t suck up wetness.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, will not blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or fall apart at the seams either. So if you own a swim spa, and you plan to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not all set to order today, bookmark this site so you can find it once again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *